Map Check Pfc; Regulation Parameters - PBI Dansensor MAP Check 9000 User Manual

MAP Check 9000 - User Manual
Three-channel scanner
The third digit indicates whether MAP Check 9000 is equipped with an automatic three-
channel scanner. MAP Check 9000 automatically detects whether the scanner control unit
has been installed. The presence of this control unit is automatically detected when MAP
Check 9000 is switched on. If this digit is set to 1 and the scanner control unit was not
detected, error message no. 33 is presented and the digit remains 0.
Current output no. 2
The fourth digit indicates whether an extra current (or voltage) output has been fitted. This
extra output always provides the measuring signal. MAP Check 9000 cannot detect whether
an extra current output has been installed. Consequently, the first digit can be changed from
0 to 1, but the unit will not inform you about the missing current output.

4.12. MAP Check PFC

Use the built-in MAP Check PFC to add the menu P.P.C (Proportional Pressure Controller):
dia.
Then add the
the current regulation flow can be read.
MAP Check PFC is set up in the following way:
PA.2
digit 4 = 0: normal MAP Check
PA.2
digit 4 = 1: normal MAP Check PFC
PA.2
When digit 4 is set to 1,
no.1) to avoid confusion (MAP Check cannot control both a built-in proportional valve and the
external MAP Con).
PA.3
ignored if digit 1 is set to 2 or 7 (MAP Con with/without by-pass).

4.12.1. Regulation parameters

The following parameters are used to control the gas regulation:
fl.in
• : Flush in flow.
lo/Hi.xx
Enter as
maintained for del. seconds.
hi.o2/lo.o2
• : Regulation window, upper/lower O
Together, these two O
tries to keep the measured O
hi.o2
value, the proportional valve is opened until the measured O
PBI-Dansensor A/S
SET DIA
reg.f
menu (diagnostics) as the first menu item
PA.3
digit 1 must be set to 1 or 0 (with/without current output
PA.2
digit 1 has a higher priority than
. When online measuring starts, it will start with flush-in-flow. This flow is
values form a window (upper and lower O
2
value within. If the measured O
2
COPYRIGHT ©
cal p.p.c
fl.in
hi.o2
lo.o2
reg.h
reg.l
g.up
g.dn
g.d
reg.f
(Regulation flow) where
PA.3
digit 1, which means that it is
limit of the desired O
2
limit) which MAP Check
2
value is higher than the
2
value is below the
2
PBI-220047-F 01/2008
4. Operation
value.
2
hi.o2
19