HARWI ORCA Series Manual page 5

APPLIANCES
The Orca vertical panel saws are only to be
used for cutting plastics, wood and wood-like
panels (e.g. chipboard, block board, MDF
etc.)
Maximum panel sizes:
- for type Orca 1850
4,3 * 1,85 * 0,060 meter
-for type Orca 2150
4,3 * 2,15* 0,060 meter
Cutting of other materials with the standard
saw-blade is prohibited. Cutting other
materials with a special saw-blade only with
permission of manufacturer.
All other appliances except for the above are
improper use of the machine and therefore
prohibited. The producer cannot be held
responsible for damage as a result of
improper use. Damage will be recovered from
the user.
The machine may not be operated, used
or maintained by persons not
acquainted with the dangers of the
machine.
Permission for operating, using and
maintaining the machine have to be
clearly described by a person or persons
responsible within the organisation.
Maintenance has to be performed by the
manufacturer or customer service.
One has to be acquainted and comply with
the country's applicable safety regulations.
Only original Harwi parts are to be used.
We cannot give warranty or be held
responsible for damage caused by using non-
original Harwi parts.
The manufacturer cannot be held responsible
for damage caused by changes made to the
machine by the user.
Remaining risks:
If the machine is completely used according
to all safety regulations there still will remain
some risks:
- Touching of the saw-blade with the
sawing area.
- Touching of the saw-blade when the
lid is opened
- Breaking of the saw-blade or parts of
the saw-blade hurtling out of the
guard.
- Touching of parts under voltage while
junction box or switch is opened.
- Damage to the hearing by constant
use of the machine without ear
protection.
- Throw out of harmful dusts or vapours.
5