Smoothening The Bottom Support - HARWI ORCA Series Manual

MAINTENANCE
SMOOTHENING THE BOTTOM
SUPPORT
Notice: See to it that the frame is adjusted
properly before the bottom support is
smoothened.
Notice: All the bottom supports have to be
smoothened at the same time.
1 Remove the plates at the front side of
the supports.
2 Position slide way at the left side of the
frame.
3 Put the saw unit in horizontal position.
4 Position the saw-blade at the same
height as the bottom supports (Fig. 26).
5 Lock motor carriage with the knob at the
right side.
6 Switch on motor.
7 Cut from left to right.
Notice: Move the slide way slowly and with
a constant speed from left to right.
8 Check if all the supports have been
smoothened.
9 If not, position slide way at the left side
of the frame, adjust the carriage a little
lower and cut again.
10 Mount the plates at the front side of
supports.
11 Adjust the pointers for the horizontal
cutting.
(see chapter: Adjusting measure).
Fig. 26
28