Adjusting The Frame - HARWI ORCA Series Manual

ADJUSTING THE FRAME

8 Adjust the angle between frame and
bottom at 80º with the M16 nuts (Fig.
11).
9 Attach cables with (lead)weights to the
horizontal bearing track at the same
heights as the vertical supports (Fig. 12).
10 Check if the distance between frame and
cables is identical. If not adjust the M16
nuts of the vertical supports to get the
same distance (fig. 11).
11 Fasten the nuts of the vertical supports
(fig. 11).
12 Fasten the bolt nut connection of the
vertical supports (Fig. 10).
13 Fasten the horizontal bolt nut connection
of the frame support (Fig. 9).
14 Adjust the face plates at both ends of the
machine in such a way that they touch
the floor.
15 Type Orca 1850 and 2150 has also a
middle face plate. Adjust it the same way.
16 Secure the face plates with the nuts.
Check if the vertical slide way can be easily
locked in the notches at the top and bottom.
The frame is adjusted correctly.
Fig. 11
Fig. 12
14