Reiteration Stop - HARWI ORCA Series Manual

REITERATION STOP

0 The purpose of the reiteration stop is to
cut smaller sheets of equal widths quickly
and repeatedly (horizontal) (Fig 19).
1 Put the saw-unit in the horizontal
position.
2 Smoothen the panel horizontally.
3 Adjust the reiteration stop at the wanted
height and fasten it (Fig. 19a).
4 Lower the saw-unit until the bearing
touches the upper side of the panel and
fasten the saw-unit.
5 Make a cut.
6 Remove the sheet.
7 For the next sheet: repeat point 4, 5 and
6.
Notice: Put the reiteration stop in its starting
position when you are finished or when
placing another panel on the machine. This
prevents damage to the stop and the panels.
Fig. 19
Fig. 19a
21