Smoothening Midway Fences - HARWI ORCA Series Manual

MAINTENANCE

SMOOTHENING MIDWAY FENCES

Notice: See to it that the frame is adjusted
properly before smoothening wooden
midway-fences.
Notice: All midway fences should be
smoothened at the same time.
Notice: The midway fences have to be
clamped so they cannot fold away while
smoothening. See to it that the saw-blade
cannot touch the clamps.
1 Pull back the riving knife (the same
way as with drop in cuts).
2 Position slide way at the left side of the
frame.
3 Put saw unit in horizontal position.
4 Position the saw-blade at the same
height as midway fences (Figure 28).
5 Lock carriage with knob at the right
side.
6 Check depth of cut
7 Switch on motor.
8 Cut from left to right.
Notice: Move the slide way slowly and with
a constant speed from left to right.
9 Check if the complete supports are
smoothened.
10 If not, position slide way again at the
left of the frame, adjust the carriage a
little lower and cut again.
11 Put riving knife back in 0-position.
12 Remove clamps.
13 Adjust arrows for the horizontal
measure.
(see chapter: Adjusting measures).
Fig. 25
27