Adjusting Measure - HARWI ORCA Series Manual

MAINTENANCE

ADJUSTING MEASURE

Re-adjusting the pointers for horizontal
measuring of the midway fences.
0 After the midway fences have been
smoothened, the pointer has to be re-
adjusted.
1 Put the saw-unit in horizontal position.
2 Position the saw-blade on the midway
fence, in such a way that it just
touches the material.
3 Lock the motor carriage.
4 Adjust the pointer at the right side of
the carriage at 0 (Fig. 27).
Re-adjusting pointers for horizontal
measuring of the bottom support:
0 After the bottom supports have been
smoothened, the pointer has to be re-
adjusted.
1 Put the saw-unit in horizontal position.
2 Position the saw-blade on the bottom
support, in such a way that it just
touches the material.
3 Lock the motor carriage.
4 Adjust the pointer at the right side of
the carriage at 0 (Fig. 28).
Adjusting the distance between pointer and
measure scale:
1 Remove the cover of the carriage.
2 Loosen adjusting screw of pointer (Fig.
29).
3 Push pointer against the measure
scale.
4 Fasten adjusting screw.
5 Mount the cover.
Fig. 27
Fig. 28
Fig. 29
29