Connecting To The Electricity Supply - HARWI ORCA Series Manual

CONNECTING TO THE ELECTRICITY SUPPLY

400V – 3 phase
You will find the wiring diagram in the
switch box.
0 Connecting the machine may only be
performed by a skilled craftsman.
1 Insert cable with four supply leads with a
diameter of 1.5 mm
box at the back side of the frame. The
quality of the cable has to be minimal
equal to H 07 RN F.
2 The cable has to be connected to the
electric fitting (Figure 13):
the 3 phases (L1, L2, L3)
...................................black or brown
the earth (PE).............yellow /green
3 Close the junction box carefully.
4 Check if the machine is provided with
fuses of 20 Amp. slow.
Notice: Check the rotation of the main saw-
blade *
* The direction of rotation is indicated on
the pressure pad. If the direction is
wrong, interchange two of three phases.
(See first next page spindle rotation).
2
into the junction
Fig. 13
15