Adjusting Measure For Horizontal Cutting - HARWI ORCA Series Manual

MAINTENANCE
ADJUSTING MEASURE FOR
HORIZONTAL CUTTING
1 Position length stop in the profile of the
upper scale at the left side of the saw
unit.
2 Lock the slide way in the zero position.
3 Put a reference gauge (a strip with an
exact width) on the machine with the
right side against the saw-blade.
4 Push the stop against the left side of the
reference gauge and read measure
(Fig 30).
5 Loosen the lock nuts at the adjusting
screws and turn in or out until the exact
measure is adjusted.
6 Lock the screws with the locking nuts.
Position length stop in the aluminium profile
of the measure scale at the left lower side of
the frame.
7 Position the stop against the reference
gauge which was put against the saw-
blade.
8 Check the measure.
9 The measure deviation can now be
corrected by moving the aluminium
profile.
10 Loosen the 6 screws a slightly (Fig. 31).
11 Adjust the profile left or right.
12 Adjust measure, fasten the screws.
The left aluminium strip of the length stop
can be adjusted the same way.
Fig. 30
Fig. 31
30