Digital Read Out (Optional) - HARWI ORCA Series Manual

DIGITAL READ OUT
ADJUSTING FROM THE TOP SIDE OF THE
MATERIAL
Put the saw unit in horizontal position
1
(Fig. 38)
Fasten the motor carriage with the knob
2
at the right side at the top of the panel.
Smoothen the panel at the top side.
3
Press button .
4
The digital read out shows an off-set
value of -3,2 mm (Fig. 40).
Notice: the off-set value equals the loss of
the saw incision.
Loosen the knob of the motor carriage
5
and adjust the needed width.
Fasten the motor carriage and cut from
6
left to right (see chapter horizontal
cutting).
Press button to reset to the off-set
7
value of -3,2 mm.
ADJUSTING OFF-SET VALUE
Frequently check the off-set value (= the
width of the cut in the material). If there is
any deviation re-adjust.
Measure the width of a test cut in the
1
material.
Press the F-button for 3 seconds, the
2
digital read out shows: ConF.
Press several times shortly the F-button
3
until the display shows P 28.
Press one more time the F-button, the
4
digital read out shows the current off-set
value.
Use the and button to change the
5
value.
Press several times shortly the F-button
6
until the digital read out shows the
normal measuring again.
Fig. 40
36
(OPTIONAL)