Direction Rotation Of The Main Saw-Blade - HARWI ORCA Series Manual

DIRECTION ROTATION OF THE MAIN SAW-BLADE

0 Block the carriage and put the saw-blade
in vertical position.
The direction of rotation is indicated on
the pressure pad (figure 14).
PROPER DIRECTION IS ANTI-CLOCKWISE
(standing at the left side of the casting)
1 Switch motor on and off.
2 Check if direction is anti clockwise.
WRONG DIRECTION IS CLOCKWISE
(standing at the left side of the casting)
1 Switch motor on and off.
2 Direction is clockwise.
3 Disconnect mains supply.
4 Interchange any two supply leads in the
junction box (at the back side of the
frame).
5 Close junction box carefully.
6 Connect the mains supply.
Notice: If the saw-blade was turning to the
wrong side the saw-blade may come
loose. Check this before operating the
machine.
(see chapter: Changing the saw-blade).
Fig. 14
16