Positioning Vertical Slide Way - HARWI ORCA Series Manual

POSITIONING VERTICAL SLIDE WAY

0 Regard the centre of gravity when
removing the slide way from the crate or
the supports. Use the cask grips on the
top when lifting the slide way. (see
Transport of the slide way with
crane/forklift truck fig. 3 and 4).
1 Dismantle bearing support at the bottom
side of the slide way by removing the
two bolts (see figure 5).
2
Adjust the two bearings of the slide way
carriage max. backwards.
3 Place slide way on the frame.
Notice: At the back side of the slide way is
a T-profile. This has to be lifted over the
tracks (figure 6).
4 Adjust the bearings of the carriage at the
top side of the slide way.
5 Assemble bearing support on bottom
side of the slide way.
6 Push the bearing support tightly against
the adjusting bolts at the front side.
7 Fasten the bearings support with two
M10 bolts.
RELEASE COUNTERWEIGHT
1 Remove the protruding bolt at the
bottom side of the track (figure 7).
2 Insert and tighten the short bolt, stuck
on the grip of the depth adjustment.
Fig. 5
Fig. 6
Fig. 7
12