STOPS FOR HORIZONTAL CUTS
0
The purpose of the stops for horizontal
cuts is to adjust measures only once and
cut panels in series (horizontal).
Preferably use the first notch to smoothen
the panel.
1
Put the saw unit in the horizontal
position.
2
Block the motor carriage with the knob at
the right side at the correct height.
3
Push the pin of the stop (Fig. 20).
4
Push a stop against the rod.
5
Fasten the stop with the allen key (Fig.
21).
6
Check the adjustment.
7
Loosen the motor carriage en move it to
the following position.
Notice: Take into account the loss of saw
incision.
8
Repeat point 2 till 6 for all adjusting
points.
9
Push in the rod.
10 Move the motor carriage till it touches a
stop.
11 Block the motor carriage.
12 Make a cut from left to right.
13 Loosen the motor carriage.
14 Push in the rod.
15 Push the motor carriage towards the next
stop.
Fig. 20
Fig. 21
22