Table of Contents
Advertisement
Gun Mounting
Electrical Connections
E 2020 Nordson Corporation
1
Figure 3
Tubing Preparation
1. Ferrule/tube compression
6. Insert the tube into the fitting body and wrench the nut down until a
sudden increase in torque is evident. Then, turn the nut an additional
1
1
/
to
/
turn.
4
3
7. Repeat steps 1 through 6 for the remaining tubes.
1. Install the gun on the spray arm of the welding machine. A mounting
rod is provided with the gun. Make sure the gun is securely mounted.
2. Connect the fluid line(s) to the system fluid line(s). Tighten the fittings
securely.
3. Connect the air line to the system air line. Tighten the fitting securely.
The remotely actuated gun must be connected to an electro-pneumatic
solenoid to provide on-off operation. For continuous spray, the solenoid can
be connected to an on-off switch and appropriate power supply. Voltage
requirements depend upon the specifications of the solenoid valve selected.
A16A Inside Stripe Gun
Part 107907-06
7
Advertisement
Table of Contents
