Installation; Tubing Preparation - Nordson A16A Customer Product Manual

6
A16A Inside Stripe Gun
COATING
PUMP
MATERIAL
SUPPLY
PLANT
AIR FILTER
AIR
(5 MICRON)
Figure 2 Remotely Actuated System Block Diagram

Installation

Tubing Preparation

Part 107907-06
HIGH
PRESSURE
HEATER
FLUID
FILTER
CIRCULATION
VALVE
AIR
PRESSURE
DRYER
REGULATOR
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
NOTE: The welding machine fluid and air lines must be configured before
connecting the gun.
1. Slip the nut and ferrule onto the tubing. Make sure the long straight end
of the ferrule is pointing towards the tube end.
2. Bottom the tubing against the tube stop in the fitting body.
3. Using oil, lightly lubricate the threads on the fitting body and the lead
and tail ends of the ferrule.
4. Pre-set the ferrule by screwing the nut down finger tight. Then, use a
wrench to tighten the nut 1
5. See Figure 3. Disassemble and inspect the ferrule/tube
compression (1).
FLUID
PRESSURE
REGULATOR
AIR
SOLENOID
VALVE
TIMER
24VDC
0.1 AMPS
3
/ turns.
4
WELD
A16A
BODY
GUN
MAKER
SENSOR
E 2020 Nordson Corporation