Shaft - Husqvarna 520iHT4 Workshop Manual

7. Install the bushing (B) and clamp (A).
8. Install the indexing ring (D), the bushing (C), the
clamp (B) and the joint (A).
A
B
C
9. Install the screw and the lower joint cover.
1235 - 001 -
B
A
D
10. Attach the lock washer and loosen the cables.
11. Install the gear package. Refer to
gear package on page 18 .
12. Install the motor. Refer to
motor on page 22 .
13. Install the air conductor. Refer to
conductor on page 17 .
14. Connect the motor cables. Refer to
install the motor on page 22 .

5.11 Shaft

5.11.1 To remove and install the shaft
1. Remove the power trigger guard. Refer to
remove and install the power trigger lockout and
power trigger on page 13 .
2. Remove the wear guard of the battery housing.
To remove and install the power trigger
Refer to
guard and the wear guard on page 13 .
3. Disassemble the control handle. Refer to
disassemble and assemble the control handle on
page 13 .
4. Disassemble the battery housing. Refer to
disassemble and assemble the battery housing on
page 14 .
To remove the
To remove and install the
To remove the air
To remove and
To
To
To
Repair instructions - 25