Banner SureCross DX80 Series Manual page 6

User Action
Apply power...
The LCD display shows the status of
the device.
RS-232 and RS-485 Communication
Three jumpers control the communication mode. To change the communication mode, change all three jumper positions. The jumpers are
shown configured for RS-485 communication.
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
Quick Start Step 2: Apply power and serial communication
Display/Status Notes
POWER This reading occurs only when power is applied to the data radio.
*RUN The data radio starts in *RUN mode.
NID 1 Displays current Network ID (NID)
(DEV) Device is ...
MASTER ... Master (Device Address = 0)
<RCVD> Indicates the number of data packets received and sent.
0
<SENT>
0
5-pin M12 Euro Hookup (RS-485)
Wire Color
1 Brown
2 White
3 Blue
4 Black
5 Gray
Do not connect dc power to the communications pins
because permanent damage may result.
Do not apply more than 5.5V dc to the gray wire.
SureCross™ FlexPower™ Data Radio
5-pin M12 Euro Hookup (RS-232 Serial)
Function
+10 to 30V dc Input
RS485 / D1 / B / +
dc common (GND)
RS485 / D0 / A / −
3.6 to 5.5V dc
Do not apply more than 5.5V dc to the gray wire.
Note, the data radio will operate equally well
when powered from the brown or gray wire. It
is not necessary to supply both.
Wire Color Function
1 Brown +10 to 30V dc Input
2 White RS232 Tx
3 Blue dc common (GND)
4 Black RS232 Rx
5 Gray 3.6 to 5.5V dc
P/N 132031 rev. E
5