Banner SureCross DX80 Series Manual page 15

SureCross™ FlexPower™ Data Radio
The DX80 Module complies with Part 15 of the FCC rules and
regulations.
FCC ID: UE3RM1809 This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
FCC Notices
IMPORTANT: The radio modules have been certified by the FCC for
use with other products without any further certification (as per FCC
section 2.1091). Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
IMPORTANT: The radio modules have been certified for fixed base
station and mobile applications. If modules will be used for portable
applications, the device must undergo SAR testing.
IMPORTANT: If integrated into another product, the FCC ID label must
be visible through a window on the final device or it must be visible
when an access panel, door, or cover is easily removed. If not, a second
label must be placed on the outside of the final device that contains the
following text: Contains FCC ID: UE3RM1809.
Note
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
Part Number
—
BWA-9O1-x
BWA-9O2-C
BWA-9O6-A
BWA-9O5-B
BWA-9Y10-A
14
P/N 132031 rev. E
FCC Certification, 900 MHz, 1 Watt Radio
Antenna Type
Integral antenna
Omni, 1/4 wave dipole
Omni, 1/2 wave dipole, Swivel
Omni Wideband, Fiberglass Radome
Omni Base Whip
Yagi
Table 1. Type certified Antenna
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiving
module,
• Connect the equipment into an outlet on a circuit different from that
to which the receiving module is connected, and/or
• Consult the dealer or an experienced radio/TV technician for help.
Antenna WARNING: This device has been tested with Reverse Polarity
SMA connectors with the antennas listed in Table 1 Appendix A. When
integrated into OEM products, fixed antennas require installation
preventing end-users from replacing them with non-approved antennas.
Antennas not listed in the tables must be tested to comply with FCC
Section 15.203 (unique antenna connectors) and Section 15.247
(emissions).
FCC-Approved Antennas
WARNING: This equipment is approved only for mobile and base
station transmitting devices. Antenna(s) used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all
persons and must not be collocated or operating in conjunction with any
other antenna or transmitter.
DX80 Module may be used only with Approved Antennas that have been
tested with this module.
Maximum Gain Maximum Power Setting
Unity gain +30 dBm
≤2 dBi +30 dBm
≤2 dBi +30 dBm
≤8.2 dBi +27.8 dBm
≤7.2 dBi +28.8 dBm
≤10 dBi +26 dBm
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164