Banner SureCross DX80 Series Manual page 10

Device Settings
Serial Line Baud Rate 19200
Serial Line Baud Rate 9600
Serial Line Baud Rate 38400
Serial Line Baud Rate 19200
Parity: None
Parity: Odd
Parity: Even
Parity: None
Transmit Power Level**: 1.00 W / 30 dBm
Transmit Power Level: 0.75 W / 29 dBm
Transmit Power Level: 0.50 W / 27 dBm
Transmit Power Level: 0.25 W / 24 dBm
RF Bit Rate**: 76.8 kbps
RF Bit Rate: 19.2 kbps
Rotary Switch Address Mode
Extended Address Mode
* Default position shown
** Disabled for 2.4 GHz. The transmit power for 2.4 GHz is fixed at 0.063 W/18 dBm and the RF bit rate is 250 kbps.
Accessing the DIP Switches
To access the DIP switches, follow these steps:
1. Unscrew the four screws that mount the cover to the bottom housing.
2. Remove the cover from the housing without damaging the ribbon cable
or the pins the cable plugs into.
3. Gently unplug the ribbon cable from the board mounted into the bottom
housing.
4. Remove the black cover plate from the bottom of the device's cover.
The DIP switches are located behind the rotary dials. After making the necessary
changes to the DIP switches, place the black cover plate back into position and
gently push into place. Plug the ribbon cable in after verifying that the blocked
hole lines up with the missing pin. Mount the cover back onto the housing.
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
SureCross™ FlexPower™ Data Radio
Configuration
1 2 3
OFF* OFF*
ON OFF
OFF ON
ON ON
OFF*
ON
OFF
ON
Turn the Power Off
Before making any changes to the DIP switch
positions, disconnect the power. For devices
with batteries integrated into the housing,
remove the battery.
Switches
4 5 6
OFF*
OFF
ON
ON
OFF* OFF*
ON OFF
OFF ON
ON ON
Address Mode
The SureCross wireless devices may use one of two types
of addressing modes: rotary switch addressing or extended
addressing. In rotary switch address mode, the left rotary
dial establishes the network ID and the right rotary dial
sets the device ID. The wireless network is restricted to a
maximum of 16 devices.
Extended address mode binds Nodes to a specific
Gateway, allowing network expansion to more than 16
devices in a wireless network. For more information on
extended address mode, refer to the SureCross™ Wireless
I/O Network product manual.
The device ships in rotary switch address mode by default,
with the DIP switch in the OFF position. To use extended
address mode, change the DIP switch to the ON position.
7 8
OFF*
ON
OFF*
ON
P/N 132031 rev. E
9