Digital Check SmartSource Expert Micro Elite Installation And Operation Manual page 21

Installation & Operations Guide - SmartSource Expert Micro Elite
When prompted by your application, insert the ID card into the alternate entry at the front of the unit, as shown. The
direction in which the ID card faces is normally out as in the graphic below. The track will start, and the ID card will be fed,
imaged on both sides, and returned to the front of the unit.
The alternate entry can also be used in the same way to feed and image single paper documents which are too thick or
too damaged to be fed through the normal feed hopper and track. Note that a MICR code line on any document fed in
this way will not be read. Refer to your application for the correct direction to feed a document through the alternate
entry.
June 2019
Processing ID Cards
ID cards
ID card or alternative feeder:
scans front and rear of card or
document. The front of the card
or document is at the left side as
shown. Application configures
scanner to start feeding on auto-
sense or by application start.
8227 6059-001 Page 21 of 30