Digital Check CheXpress CX30 Setup

Hide thumbs Also See for CheXpress CX30:

Download this manual

CheXpress

CX30 User Manual

Rev 042516

CheXpress CX30 Initial Setup

New User Notice

Do not connect the 'USB' cable from the scanner to your PC before installing the 'drivers' or

PLEASE NOTE:

the 'scanning application / software'. Digital Check does not provide scanning software. Please contact your

bank or other solution provider for further assistance with installing the driver or getting the scanning software

set up or installed.

Digital Check provides only an optional driver installation utility and a separate demonstration program.

See the 'Installing the Optional USB Driver' section or the 'Installing ScanLite2' section for additional

information.

Unboxing the CheXpress CX30

Lay the box on its side and slide out the packaging and scanner. Lift off the top plastic insert (the 'USB' cable is

inside), then lift the scanner from the bottom insert.

Page | 8

Page 1 Do not connect the ‘USB’ cable from the scanner to your PC before installing the ‘drivers’ or PLEASE NOTE: the ‘scanning application / software’. Digital Check does not provide scanning software. Please contact your bank or other solution provider for further assistance with installing the driver or getting the scanning software set up or installed.
Page 2 Disconnecting the USB and Power Supply Cables When removing or disconnecting the ‘USB’ or ‘Power Supply’ cables from the CheXpress CX30, be sure to pull straight back on the cable and remove as shown below. Do not remove the cable by pulling up, vertically or at an angle. Doing so can damage the connector. The cables must be removed by gently pulling straight back on the cable from the connector.