TDK-Lambda Genesys series Technical Manual page 26

button on the power supply front panel
Measurements: This section displays the selected power supply's actual output voltage
and current and the operating mode (constant-voltage or constant-current or off). Also,
faults are shown in the voltage display
Settings: This section displays the selected power supply's voltage and current limit
settings (as if they were set on the front panel encoders)
Modify Settings: This button is disabled (gray text) until you login (see section 5.3). After
logging in, click this button to open the window shown below
5.4.2. DC Power ‡ Output ‡ Modify Settings Page
After you have logged in and clicked the "DC Power ‡ Modify Settings" button, a pop-up
window shows:
In this window, you may enter new values for the voltage and current limits and turn the
output on and off. The new settings will not take place until the "Apply" button is clicked and
the pop-up window closes
5.4.3. DC Power ‡Protection Page
Under the "DC Power" tab, a "Protection" button is available at the top of the panel. When
opened, the window that allows you to view and set four protections. The "Apply" buttons
are not enabled until you log in
Note, a control slider on the right side of the panel is needed to view all four settings, which
are:
B. Over-Voltage Protection
C. Under-Voltage Limit
D. Foldback Protection ON or OFF
E. Auto-Start or Safe-Start
In a multi-drop chain, these settings affect only the supply selected in the RS-485 address
listbox
5.4.4. DC Power‡ System Page
Under the "DC Power" tab, a "System" button is available at the top of the panel. When it is
clicked, the window that allows you to operate four functions:
A. Reset One Instrument
(this resets only the supply selected in the RS-485 address listbox)
B. Reset All Instruments
(see section 7.5.1)
(see section 7.5.2)
(see section 7.5.4)
(see section 7.4.3)
(see section 7.7.2)
(see section 7.7.2)
22