Configuring The Serial V.35/Rs-449/Rs-530 Network Interface - Polycom HDX Series Administrator's Manual

Administrator's Guide for Polycom HDX Systems

Configuring the Serial V.35/RS-449/RS-530 Network Interface

2 - 20
To configure the V.35/RS-449/RS-530 network interface settings:
1. Go to System > Admin Settings > Network > V.35/RS-449/RS-530.
2. Configure these settings:
Setting
Enable
V.35/RS-449/RS-530
V.35 Ports Used
RS-366 Dialing
Area Code
Port 1
Port 2
3. Select and configure these settings:
Setting
Prefix
Calling Profile
Speed
Description
Allows the system to connect to a terminal adapter using
a V.35, RS-449, or RS-530 connection.
Specifies whether one or two lines are connected.
Allows users to dial calls from this system.
Clear this setting if this is a dedicated connection or if
another device is used for dialing calls.
Specifies the area code and number(s) that other sites
dial to reach this system.
If this is a dedicated connection, leave these fields blank.
Description
Lets you specify the dialing prefix required to reach an
outside line.
Lets you specify what data communications equipment is
connected to the network interface. The system
automatically displays the default prefixes, suffixes, and
calling speeds required by that device.
If your device is not listed, select Custom.
Lets you define the prefixes or suffixes to use for each
speed used in a Custom Calling Profile. For information
about required prefixes and suffixes, see the
documentation that came with the device.
If you choose a predefined Calling Profile, this
information is supplied for you.