Polycom HDX Series Administrator's Manual page 46

Administrator's Guide for Polycom HDX Systems
3 - 4
Setting Description
Video Format Specifies the monitor's format:
• DVI — Select if the monitor is connected to the DVI connector
using a DVI cable. DVI resolutions can be 1024 x 768 or 1280
x 720.
• VGA — Select if the monitor is connected to the DVI
connector using a VGA cable. VGA resolutions can be 1024 x
768 or 1280 x 720.
• Component YPbPr — Select if the monitor is connected to
the DVI connector using component cables.
• S-Video — Select if the monitor is connected to the BNC
connectors using an S-Video cable.
• Composite — Select if the monitor is connected to the BNC
connectors using a composite video cable.
Note: If you select 16:9, you will also need to set up the monitor
for full-screen display. In the monitor's setup menu, choose the
setting that stretches the picture uniformly without clipping the
edges, which is usually called Full, Wide screen, or 16x9.
Use this setting:
Resolution Specifies the resolution for the monitor.
Output Upon Specifies the screen saver output for Monitor 2:
Screen Saver
Specifies whether black video or no signal is sent to the monitor
Activation
when the system goes to sleep and the screen saver activates.
Select Black if you want to display black video. This is the
recommended setting to prevent burn-in for TV monitors.
Select No Signal if you want the display to react as if it is not
connected when the system goes to sleep. This is the
recommended setting for VGA monitors and projectors.
Display Near Specify whether to display near video on this monitor.
Video
Display Far Specify whether to display far video on this monitor.
Video
Display Specify whether to display content on this monitor.
Content
Not this setting: