Table of Contents
Advertisement
To adjust the volume of both channels as a stereo pair (default):
1. On the main screen, press the Phones button to access phones output settings.
2. Press the '3|4' selection button to access output channel 3 and 4.
3. Adjust the volume using the encoder.
To separate Output Channels 3 and 4:
1. Open output channel 3|4 as above.
2. Press the encoder to open additional settings.
3. Click the "Stereo" button to separate the channels.
10.3. MADI Outputs
The MADI outputs of the AVB Tool are always active. If no routing is configured, an empty stream is sent
that can be used for clocking. The state without routing is represented with a light-green Status Indicator.
For instructions on how to create a routing to the MADI Output, see Routing Signals to the Outputs.
10.3.1. Setting the Output Channel Format and Frame Pattern
Depending on the requirements of the receiver, it is possible to change the channel format and frame
pattern of the outgoing MADI streams.
To change the channel format of both MADI outputs on the device:
1. Go to one of the MADI tabs in the OUTPUT section.
2. Toggle the switch to 56Ch or 64Ch to adjust number of output channels.
56Ch and 64Ch format correspond to 28/32 channels at double speed, and to 14/16
channels at quad speed.
To change the frame pattern of both MADI outputs on the device:
1. Go to one of the MADI tabs in the OUTPUT section.
2. Toggle the switch for 96k to use the 96k frame at 88.2 kHz and 96 kHz.
96k frame setting is only used at sample rates 88.2 kHz and 96 kHz and is otherwise
ignored.
59 | 10.3. MADI Outputs
RME AVB Tool User's Guide
Advertisement
Table of Contents
