Table of Contents
Advertisement
6. Quick Start (MADI)
Follow this procedure to send microphone input signals to the digital outputs.
1. Load Preset 1 from the STATE>Preset tab. If
Preset 1 has been modified, load the Factory
preset and create a routing first Routing Signals
to the Outputs.
3. After connecting an analog signal, adjust its
gain level as needed: press the button next to the
input.
done! The channel is sent to the MADI and AVB outputs.
25 | 6. Quick Start (MADI)
RME AVB Tool User's Guide
2. In the CLOCK section, choose a sample rate
and verify that the device is clock master or that
the chosen clock source is in sync.
4. Then, use the buttons and encoder next to the
display to adjust settings as needed.
Advertisement
Table of Contents
