Axis DIGITAL LINE L06DUS Installation And Use Manual page 48

Maintenance
5
MALFUNCTIONS: TROUBLESHOOTING
1
Please refer to the table below: if the problem cannot be solved, continue the procedure.
PROBLEM TROUBLESHOOTING
In START mode, the
- Door open
appliance does not
- Microswitch not indicating that door is closed
start
- Bulb is loose
Cavity light off
- Bulb is burnt out
- The fans fail to reverse direction
The oven does not - One of the fans is not moving
cook food evenly - On of the heating elements is broken
- Door seal out of place
- No mains power
The appliance is fully
- Appliance connected to the power mains incorrectly
turned off.
- Safety thermostat triggered
Water is not intro- - Water inlet closed
duced in the humidifi- - Incorrect connection to the water supply
cation pipes - Water supply filters clogged with impurities.
Water escapes from - Seal dirty
the seal when the - Seal is damaged
door is shut - Problem with door closing mechanism
The fan stops during - Motor safety thermostat triggered
operation - Motor condenser broken
48
- Make sure the door is shut.
- Contact a specialised technician for
repairs (Customer Support Service)
- Insert the bulb into the lighting fixture
correctly
- Replace the bulb
- Contact a specialised technician for
repairs (Customer Support Service).
- Contact a specialised technician for
repairs (Customer Support Service).
- Contact a specialised technician for
repairs (Customer Support Service).
- Reposition the appliance door seal
correctly.
- Restore the electrical power supply.
- Make sure the appliance is connected
to the electricity mains.
- Contact a specialised technician for
repairs (Customer Support Service).
- Open water inlet.
- Make sure the appliance is connected
to the water supply.
- Clean the filters
- Clean the seal using a damp cloth
- Contact a specialised technician for
repairs (Customer Support Service).
- Contact a specialised technician for
repairs (Customer Support Service).
- Turn the appliance off and wait for
the thermal cut-off device in the
motor to reset automatically. If the
problem persists, contact a specialised
technician for repair work (customer
support service). Check the appliance
safety clearance distances have been
respected.
- Contact a specialised technician for
repairs (Customer Support Service).