Siemens SIMATIC Series Operating Instructions Manual page 93

2. Screw from outside the drive bay plate on the inside to the side wall of the enclosure, at
position
3. Connect the SATA cables to the required SATA connectors of the motherboard and to the
drive (position
4. Connect the power supply.
5. Close the device.
Replacing the drive
1. To remove the drive, following the described procedure in the reverse order.
2. Reverse the procedure to install the drive.
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
① ②
or position . The SATA connections each lie in the middle
③
).
Expanding and assigning parameters to the device
6.6 Drives
③
.
93