Expanding and assigning parameters to the device
6.6 Drives
3. Grip the front of the DVD
on the left and the right and pull it
completely out of the device.
4. Carefully set down the DVD drive
in the drive bay
5. Remove the SATA connector
from the DVD drive.
Replace the DVD drive and
reconnect the SATA connector to
the DVD drive.
Take care not to touch the
contacts when you do this.
6. Push the drive bay into the
installation slot
until it snaps into place at the
back.
7. Place all the SATA cables into
the cable holder
See also
Removing and installing a 3.5"/2.5" drive in drive cage type B (Page 80)
102
③
drive
④
, as shown.
⑤
⑥
from the front
①
and close it.
Operating Instructions, 04/2020, A5E49948632-AA
SIMATIC IPC547G