Hard Disk Or Ssd, Device With Drive Cage Type A; Installing A Hard Disk Drive Or Ssd In Slot 0 To 2 - Siemens SIMATIC Series Operating Instructions Manual

6.6.6

Hard disk or SSD, device with drive cage type A

Requirement
● The device is equipped with the drive cage type A.
● The device is fully disconnected from the mains voltage, see section "Switching off the
device (Page 63)".
● The device is open; see section "Open the device (Page 76)".
● Screwdriver T10 for loosening the HDD
● Screwdriver T8 for loosening the SSD
See also
Opening the front door (Page 76)
6.6.6.1

Installing a hard disk drive or SSD in slot 0 to 2

Procedure
1. Press the locks
2. Push the locks to the front in the direction of the arrow
3. Remove the cover
4. Remove the now freely accessible slot cover
removable trays until the drive cage is freely accessible.
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
① ③
of the cover together inside the device and keep them pressed.
③
upwards at an angle at the front of the device.
Expanding and assigning parameters to the device
②
.
④
. If required, remove other slot covers or
6.6 Drives
89