Installing Windows - Siemens SIMATIC Series Operating Instructions Manual

7.5.4

Installing Windows

Note
Specific information on using the Windows operating systems is available on the Internet:
• Microsoft Technet Windows (http://technet.microsoft.com/windows)
• Microsoft Technet Windows Server (http://technet.microsoft.com/windowsserver)
Requirement
You need the Recovery DVD for the operating system you want to install. This is included in
the product package if you have ordered a device with an operating system.
If you use storage controllers that are unknown to the operating system, for example a RAID
or AHCI controller, copy the respective controller driver to a USB stick and keep this USB
stick to hand. The controller driver is required during installation.
Note
Operation of older operating systems with USB keyboard and mouse
Select the "PS/2 Emulation" setup parameter in the "Advanced > USB Configuration" menu
of the BIOS Setup if you are using the USB keyboard and USB mouse for the following:
• Recovery of Windows 7 and Windows Server 2008 R2
• Update of USB driver in installed Windows 7 and Windows Server 2008 R2
Use of the Trusted Platform module TPM 2.0 under Windows 7, Windows Server 2008 R2 and 2012
R2
If you install the operating system yourself, the following requirements must be met:
● The operating system is installed and booted with the setting "UEFI Boot Type".
During installation the drive is set up as a GBT partition.
● Hotfix KB2920188 has been installed More information can be found on the Microsoft
homepage "Support for TPM 2.0 (https://support.microsoft.com/en-us/kb/2920188)".
Procedure
1. If your device has no DVD drive, connect an external USB DVD drive to a USB port.
2. Insert the Recovery DVD into the DVD drive.
3. Reboot the device.
4. Press the <F12> key when the device boots and keep it pressed.
The boot menu is displayed after initialization is completed.
SIMATIC IPC547G
Operating Instructions, 04/2020, A5E49948632-AA
Device maintenance and repair
7.5 Installing the software
129