TOHATSU BFT 200D Owner's Manual page 105

WATER SEPARATOR CUP
O-RING (Replace)
5. Remove the three screws holding
the fuel filter with water separator,
empty the water or deposits from
the inside of the cup.
6. Thoroughly clean the cup, and
replace with a new fuel filter.
7. Reassemble the fuel filter with
water separator in the reverse order
of removal. Use a new O-ring.
TIGHTENING TORQUE:
2.5 lbf·ft (3.4 N·m, 0.35 kgf·m)
SCREWS
SERVICING YOUR OUTBOARD MOTOR
8. Position the aligning mark as
9. Prime the engine using the
ALIGNING MARK
SUSPENSION STRAP
shown in the figure when
installing the suspension strap on
the fuel filter with water separator.
priming bulb (p.55). Check for fuel
leaks. Repair any fuel leaks if
necessary.
103