Summary - ZyXEL Communications NXC Series User Manual

• Channel Width: Select the wireless channel bandwidth you want the managed AP to use. Because
not all devices support 40 MHz and/or 80 MHz channels, select 20/40/80MHz to allow the AP to adjust
the channel bandwidth automatically.
• Maximum Output Power: Enter the maximum output power of the managed AP. If there is a high
density of APs in an area, decrease the output power of the managed AP to reduce interference
with other APs. The default output power settings vary depending on the time zone you selected.
Note: Reducing the output power also reduces the managed AP's effective broadcast
radius.
Figure 28 Wizard: Step 5 Radio

4.2.6 Summary

Use this screen to check whether what you have configured is correct. Click Save to save your settings
and complete the wizard setup. Otherwise, click Prev to return to the previous screen or click Cancel to
close the wizard without saving.
To configure advanced settings on date/time, the uplink connection, a VLAN interface, and managed
APs, go to the configuration screens after you finish setting up the Wizard.
Chapter 4 Setup Wizard
NXC Series User's Guide
55