Ap Policy - ZyXEL Communications NXC Series User Manual

Table 56 Configuration > Wireless > AP Management > Mgmt. AP List > Edit AP List (continued)
LABEL
Automatically
Extinguish After
Reset AP Configuration
This section is available only when the AP is online.
Apply Factory
Default
OK
Cancel

8.3.2 AP Policy

Use this screen to configure the AP controller's IP address on the managed APs and determine the
action the managed APs take if the current AP controller fails. Click Configuration > Wireless > AP
Management > AP Policy to access this screen.
Figure 71 Configuration > Wireless > AP Management > AP Policy
Each field is described in the following table.
Table 57 Configuration > Wireless > AP Management > AP Policy
LABEL
General Settings
Force Override
Controller IP Config
on AP
Override Type
Chapter 8 Wireless
DESCRIPTION
Enter a time interval between 1 and 60 minutes to stop the locator LED from blinking. The
locator LED will start to blink for the number of minutes set here.
If you make changes to the time default setting, it will be stored as the default when the AP
restarts.
Click the button to reset all of the AP settings to the factory defaults.
Click OK to save your changes back to the NXC.
Click Cancel to close the window with changes unsaved.
DESCRIPTION
Select this to have the NXC change the AP controller's IP address on the managed AP(s) to
match the configuration in this screen.
Select Auto to have the managed AP(s) automatically send broadcast packets to find any
other available AP controllers.
Select Manual to replace the AP controller's IP address configured on the managed AP(s)
with the one(s) you specified below.
NXC Series User's Guide
130