Add/Edit Trusted Client - ZyXEL Communications NXC Series User Manual

Figure 227 Configuration > System > Auth. Server
The following table describes the labels in this screen.
Table 181 Configuration > System > Auth. Server
LABEL
General Settings
Enable
Authentication
Server
Authentication
Server Certificate
Authentication
Method
Trusted Client
Add
Edit
Remove
Activate
Inactivate
#
Status
Profile Name
IP Address
Mask
Description
Apply
Reset

29.12.1 Add/Edit Trusted Client

Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add icon or an
Edit icon to display the following screen. Use this screen to create a new entry or edit an existing one.
Chapter 29 System
DESCRIPTION
Select the check box to have the NXC act as a RADIUS server.
Select the certificate whose corresponding private key is to be used to identify the NXC to the
RADIUS client. You must have certificates already configured in the My Certificates screen.
Select an authentication method if you have created any in the Configuration > Object > Auth.
Method screen.
This specifies from which computers you can access which NXC zones.
Click this to create a new entry. Select an entry and click Add to create a new entry after the
selected entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The NXC confirms you want to remove it before
doing so. Note that subsequent entries move up by one when you take this action.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This is the index number of the entry.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field indicates the name assigned to the profile.
This is the IP address of the RADIUS client that is allowed to exchange messages with the NXC.
This is the subnet mask of the RADIUS client.
This is the description of the RADIUS client.
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
NXC Series User's Guide
372