Bosch MUC6 Series Instruction Manual page 16

en Preparation
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for the selected preparation
programme flashes.
2. Press button G to start the preparation
programme.
The appliance heats up the pan until the
target temperature is reached. During the
heating phase, lines that light up in a clock-
wise direction appear in the display.
Once the target temperature is reached,
the lines go out and the preparation time is
shown in the display.
The preparation process starts
automatically.
Note: when the programme [ паста ] (pasta)
or [ фритюр ] ( deep frying) is selected, a
repeating audible signal is emitted and the
display and button G flash until the food
has been added and button G has been
pressed.
The preparation time counts down.
Steam is created during cooking which
escapes from the appliance to avoid excess
pressure to build.
14
MUC6-8_RU_8001018000.indb 14
Increasing or reducing the temperature
If the current temperature was set too high
or too low during the preparation, this can
be increased (by +10°C max.) or decreased
(by -10°C max.) accordingly during the
cooking process.
To increase the temperature, press and
hold the C button. The current temperature
will briefly be shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and hold
the C button. The current temperature will
briefly be shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower). Press and hold the button
until the temperature is at the reduced level
desired.
To continue with the preparation
programme,.press the G button.
Note: If the G button is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds and the indicator
[ готово ] (ready) and button G light up,
or the Keep warm function is activated.
X "Keep warm function" see page 16
The display flashes and shows "00:00".
3. Open the lid of the appliance and serve
the meal that has been prepared.
W Warning
Risk of burns!
■ During preparation, large amounts of
steam accumulate in the appliance.
Always open the lid with care. Do not
lean over the lid of the appliance.
■ The pan and any inserts that are used
may be very hot. Always use corre-
sponding handles or oven gloves.
16.07.2015 12:15:08