Bosch MUC6 Series Instruction Manual page 13

Preparation with steam pressure
There are 8 pre-configured preparation
programmes to choose from, which can
be used with the steam pressure function.
X "List of preparation programmes" see
page 22
W Warning
Risk of burns!
■ Frothy ingredients like milk and cream
must not be heated up under steam
pressure.
■ Do not use the steam pressure function
to deep fry food with oil under pressure.
1. Open the appliance. Open the pressure
locking handle (M) and press the
opening button on the base appliance
for this purpose.
2. Fill the pan with the desired ingredients.
The measuring scale on the inside of
the pan can also be used to read the
quantity.
Warning!
■ Never heat up the appliance under
steam pressure without having added
water or other liquids beforehand. Add
at least 250 ml of water.
■ Do not fill the pan beyond the marking
[ 3.5 ] !
■ If food is prepared that expands during
cooking, fill the pan up to a maximum
as described in the recipe suggestions.
(For example rice: maximum of 800 g).
X See recipe book provided
3. Close the appliance. Press the lid down
for this purpose until it clicks into place
and close the pressure locking handle
(N).
An audible signal sounds. The steam
pressure function is switched on.
4. Press button B in order to access the
function selection mode.
MUC6-8_RU_8001018000.indb 11
The desired preparation programme is
selected in the function selection mode and
all settings of the appliance are made. The
B button lights up permanently as well as
the indicators [ мой режим ] (My mode) and
[ K ]. Button G flashes. "00:00" is shown in
the display.
Note: If no input is made on the control
panel within 5 minutes, the appliance auto-
matically switches to standby mode.
5. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for the selected preparation pro-
gramme flashes. The indicator "low steam
pressure" [ K ] or "high steam pressure"
[ L ] lights up. Press the L button to toggle
between [ K ] and [ L ].
Note: If [ K ] or [ L ] does not light up, the
steam pressure function is not available for
the selected programme.
Preparation en
11
16.07.2015 12:15:06