Table of Contents
Advertisement
Additional Connector Information
HDMI connectors
Use a LockIt Lacing Bracket to securely fasten each HDMI cable to the
switcher as follows.
1.
Plug the HDMI cable into
the panel connection.
2.
Loosen the HDMI
connection mounting screw
from the panel enough
to allow the LockIt lacing
bracket to be placed over
it. The screw does not have
to be removed.
3.
Place the LockIt lacing
bracket on the screw
and against the HDMI
connector, then tighten
the screw to secure the
bracket.
ATTENTION:
•
Do not overtighten the HDMI connector mounting screw.
The shield it fastens to is very thin and can easily be
stripped.
Ne serrez pas trop la vis de montage du connecteur HDMI.
•
Le blindage auquel elle est attachée est très fin et peut
facilement être dénudé
4.
Loosely place the included tie wrap around the HDMI connector and
the LockIt lacing bracket as shown.
5.
While holding the connector securely against the lacing bracket, use
pliers or similar tool to tighten the tie wrap, then remove any excess
length.
3 3
1 1
3
4 4
5 5
DTP CrossPoint 84 • Installation
2 2
9
Advertisement
Table of Contents
