Audio Inputs And Outputs - Extron electronics DTP CrossPoint 84 Setup Manual

Scaling presentation matrix switchers with dtp extension
Hide thumbs Also See for DTP CrossPoint 84:
Table of Contents

Advertisement

XTP position — Select if the receiving device is an Extron XTP matrix
switcher. The output is HDMI with embedded audio plus RS-232 and IR.
HDBT position — Select if the receiving device is a HDBaseT-enabled
device. The output is HDMI with embedded audio plus RS-232 and IR.
DTP position — Select if the receiving device is an Extron DTP
device. The TP output is compatible with a DTP receiving device and
consists of HDMI with embedded audio, analog audio, RS-232 and IR,
and remote power.
TP Outputs 3 and 4 — (see
F
compatible Extron DTP receivers, XTP matrix switchers,
or HDBaseT-enabled devices into these RJ-45 ports using
STP cables (see
connector).

Audio Inputs and Outputs

4
S/PDIF
OUT
RESET
Figure 4.
Audio Inputs 1 through 6 — Plug balanced or unbalanced
G
stereo audio inputs into these 3.5 mm, 5-pole captive screw
connectors (see
page 13 to wire the connectors).
Mic/Line Inputs 1 through 4 — Plug microphones or other
H
mono audio inputs into these 3-pole, 3.5 mm captive screw
connectors (see
the connectors).
+48 V (phantom power) LEDs — Light to indicate +48 V
I
phantom power is switched on via software.
Audio Outputs 1 through 4 — Plug audio devices such
J
an audio amplifier or powered speakers to these 3.5 mm,
5-pole captive screw connectors (see
connectors
Amp Output 1 (SA [stereo] model) — Plug passive,
K
4-ohm or 8-ohm speakers to this 5 mm 4-pole captive
screw connector to receive the amplified audio from
output 1.
6
DTP CrossPoint 84 • Installation
TP connectors
ATTENTION:
Do not connect this port to a computer data or
telecommunications network.
Ne connectez pas ces port à des données informatiques ou
à un réseau de télécommunications.
REMOTE
Tx Rx G
L
R
L
R
1
3
4
2
L
R
L
R
EXP
Video Output Features
Local and Mic/Line audio connectors
Local and Mic/Line audio connectors
to wire the connectors).
figure 2
on page 4) Plug
on page 10 to wire the
8
/
4
1
L
R
CLASS 2 WIRING
+48V
L
R
L
R
L
1
5
1
3
1
MIC/LINE
2
6
2
2
4
L
R
L
R
L
3
4
Local and Mic/Line audio
SIG
R
3
4
R
on
to wire
8
/
1
L
CLASS 2 WIRING
LINK
OUT
L
R
+48V
1
2
L
R
4
R

Advertisement

Table of Contents
loading

Table of Contents