Table of Contents
Advertisement
Figure 15.
2.
If necessary, select the DTP CrossPoint switcher in the drop-down
menu and click OK.
The DSP Configurator program starts in Emulate mode (see
on the next page).
30
DTP CrossPoint 84 • Remote Control
2 2 2 2
2 2 2 2 2 2 2 2
2 2 2 2 2 2
DSP Configurator Screen and Device Selection
TIP:
You can also launch the DSP Configurator program from
within the Product Configuration Software.
TIP:
If you have only DTP CrossPoint switchers of the same
model, click Always perform the selected operation to
eliminate step 2 in future startups.
NOTE:
In Emulate mode, changes and settings are stored
in the PC and not sent to the switcher until you select Live
mode and "push' the settings to the switcher. See the
DTP CrossPoint 84 Switcher User Guide .
figure 15
Advertisement
Table of Contents
