Audio Inputs And Outputs - Extron electronics DTP CrossPoint 84 Setup Manual

F
TP Outputs 3 and 4
DTP receivers, XTP matrix switchers, or HDBaseT-enabled devices into these
RJ-45 ports using STP cables (see
connector).
ATTENTION:
•
•

Audio Inputs and Outputs

4
S/PDIF
REMOTE
OUT
RESET
Tx Rx G
Figure 4.
G
Audio Inputs 1 through 6
stereo audio inputs into these 3.5 mm, 5-pole captive screw connectors (see
Local and Mic/Line audio connectors
Mic/Line Inputs 1 through 4 — Plug microphones or other mono audio inputs
H
into these 3-pole, 3.5 mm captive screw connectors (see
audio connectors
+48 V (phantom power) LEDs — Light to indicate +48 V
I
phantom power is switched on via software.
Audio Outputs 1 through 4 — Plug audio devices such an audio amplifier
J
or powered speakers to these 3.5 mm, 5-pole captive screw connectors
(see Local and Mic/Line audio connectors
Amp Output 1 (SA [stereo] model) — Plug passive, 4-ohm or 8-ohm
K
speakers to this 5 mm 4-pole captive screw connector to receive the
amplified audio from output 1.
Amp Output 1 (MA [mono] model) — (see
L
Connect passive high-impedance speakers to this 2-pole captive sc
connector to receive the amplified audio from output 1.
S/PDIF Output 4 — Plug a compatible device
M
with a 75-ohm digital audio cable to receive a digital audio signal from the
output 4 digital stream.
N
DMP Expansion Port and LED
Expansion Port — Plug an STP cable between this port and the
Expansion port on an optional Extron DMP 128 ProDSP Digital Matrix
Processor.
Link LED — Lights to indicate that the port is connected to a compatible device.
DTP CrossPoint 84 • Installation
— (see figure 2 on page 4) Plug compatible Extron
Do not connect this port to a computer data or telecommunications network.
Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
8 / 4
1
L R
CLASS 2 WIRING
+48V
L R L R L R L R
1
1 3 5 1 3 1
MIC/LINE
2
2 4 6 2 4 2
L R L R L R L R
3
4
EXP
Video Output Features
— Plug balanced or unbalanced
to wire the connectors).
—
TP connectors on page 8 to wire the
L R
3
4
L R
on page 11 to wire the connectors).
Local and Mic/Line
to wire the connectors).
figure 2 on page 4)
this RCA connector
into
SIG LINK
OUT
L R
+48V
1
2
L R
8 / 4
1
L R
CLASS 2 WIRING
rew
1
CLASS 2 WIRING
S/PDIF
OUT
EXP
6