Eaton i-on Series Engineering Manual page 31

8. Select the wiring type you intend to use for wired zones (page 7):


This determines the default wiring type for the control unit and any attached bus
devices, such as wired expanders. You can change the control unit's wiring type
through Installer menu – System Options, or specify a different wiring type for a bus
device through the device's edit menu (e.g. Installer menu – Detectors/Devices –
Wired Expander – Edit Expander).
Note: If you are using an ADP-10CC board (to provide ten on-board 4-wire CC zones
instead of ten FSL zones), select 2-wire FSL 2k2/4k7 as the wiring type.
9. Specify an installer code:


When prompted, confirm the code. DO NOT FORGET THIS CODE!
10. You will see one of the following:
 If the lid of the control unit is closed, you will see the standby screen. For
example:


 If the lid of the control unit is open, you will see:


11. If the standby screen is displayed, enter the Installer code to enter the Installer menu.
Otherwise, if the "Panel lid open" message is displayed, press  to access the
Installer menu.
The first option in the menu is displayed:


12. Use the Installer menu to carry out the required configuration tasks, such as to:
 Add the other bus devices, if used (page 50).
 Program zones.
 Configure outputs.
 Configure setting options.
13. Exit the Installer menu (page 23).
Getting Started
Page 21