Eaton i-on Series Engineering Manual page 117

Four wrong user codes (also called "User code tamper"
461
or "excess keys")
573 User/system zone omit. Zone omit restore.
575 Bypass (shunt)
625 Time and date reset
627 Installer mode start keypad (web)
628 Installer mode end keypad (web)
*Note:
1. The control unit communicates Jamming, Supervision when the system is unset.
Table 16: SIA Report Groups
SIA Code Includes:
AT, AR Mains fail and restore
AT, AR External PSU AC fail and restore
BA, BR Burg and Burg restore
BB, BU
User/system zone omit. Zone omit restore. Burglary
Bypass (shunt)
BC Alarm Abort
BT, BJ Masking fault and restore
BV Alarm confirmation
BZ
Zone supervision fail and restore
Radio keypad supervision fail and restore
External siren supervision, fail and restore*
Internal radio sounder supervision, fail and restore
WAM supervision fail and restore
CE Calendar set deferred
CL System or partition part set
CL, OP System or partition set and unset
CS System or partition keyswitch part set
CS, OS System or partition keyswitch set and unset
EA Exit timeout and restore
EJ, ES Missing bus device and restore
Tamper bus device and restore
ET, ER Bus device aux fuse fault and restore
ET, ER Bus device low voltage fault and restore
YP, YQ External PSU fault and restore via zone n
FA, FR Fire and fire restore
FT, FJ Smoke fault and restore
HA, HR Duress
HV Hold Up Alarm Confirmed
IA, IR 4k4 Fault and restore on zone n
JA User code tamper (excess keys)
Test Menu
Page 107
Tampers
Omit
Omit
Time Date Reset
Installer Mode
Installer Mode
SIA Report Group
Mains Fail
Faults
Burglar Alarm
Omit
Burglar Alarm
Burglar Alarm
Masking
Burglar Alarm
RF Supervision
Set/Unset
Part Set
Set/Unset
Part Set
Set/Unset
Exit Timeout
Tampers
Faults
Faults
Fire Alarm
Faults
Hold Up Alarm
Faults
Masking
Tampers