Installing Your Digitizer; Installing The Software - Microtek Medi-2200 Plus User Manual

Installing Your Film Digitizer

Installing the Software

Important: Do not remove the yellow stickers from your digitizer until you are
told to do so. You must install all software before connecting your digitizer.
Always close any open programs and turn off Anti-virus utilities before installing
software.
1. Turn on your computer.
2. Place the Medi-2200 Plus CD-
3. Follow the on-screen
4. To install the software on the Medi-2200 Plus CD, click each software
5. Click EXIT on the Microtek Software Installer screen when all the software
6. Restart your computer.
Drivers & Software Upgrades
After you finish the installation of software, if you found that the installed drivers and software
cannot run your product or your computer system properly later, please go to the Microtek
Download Service site at www.microtek.com/service.php to download and install any updates you
may require.
For additional information about Microtek products, please visit our website at www.microtek.com.
ROM into your CD-ROM drive.
instructions to install the driver
and software.
NOTE: If the Microtek Software
Installer screen does not come
up automatically, double-click
the following in succession:
"My Computer"; the CD-ROM
icon; then cdsetup.exe to start
the installer program.
program in the order that it appears on the screen to install, and follow the
on-screen instructions.
has been installed.
Medi-2200 Plus User's Manual 19