Installing Your Film Digitizer; Installing The Software - Microtek Medi-7000 User Manual

Film imaging digitizer

Hide thumbs Also See for Medi-7000:

Table of Contents

Installing Your Film Digitizer

Important: You must install software before connecting your digitizer.

Always close any open programs, and turn off Anti-virus utilities before installing

software.

1. Turn on your computer.

2. Place the Microtek CD into your CD-

3. Follow the on-screen instructions to

4. Click EXIT on the Microtek Software Installer screen when all the software

5. Restart your compute.

Drivers & Software Upgrades

After you finish the installation of software, if you found that the installed drivers and software

cannot run your product or your computer system properly later, please go to the Microtek Download

Service site at microtek.com/en/download to download and install any updates you may require.For

additional information about Microtek products, please visit our website at www.microtek.com.

ROM drive.

install the driver and software.

NOTE: If the Microtek Software

Installer screen does not come up

automatically, double-click the

following in succession: "My

Computer"; the CD-ROM icon; then

cdsetup.exe to start the installer program.

have been installed.

Medi-7000 User's Manual

Table of Contents