Operating Instructions; Before Using; First Firing; Regulating The Airflow - Heta SCAN-LINE TURIN CLASSIC Operating And Installation Instructions

1. oPeratinG instrUCtions

1.1 Before using

Before the wood stove is used make sure
required installation conditions, are met. See
page 14.

1.2 first firing

The stove paint is fully cured from the factory,
but a minor unpleasant odour could still arise.
1.3 regulating the air flow
To open the flow of combustion air, use the ope-
rating handle at the back of the side panel. The
combustion airflow is completely open in top
position, fig. 1. Shut off the combustion airflow
gradually by lowering the handle. The supply
is completely shut off when the handle is at its
bottom position, fig. 2.
1
Open

1.4 lighting the stove

Place two pieces of wood on the bottom. Stack
kindling on top in layers with air between. Set
ting fire starter (bag, brick, paraffin) on the top,
now you are ready to light the fuel. The flames
must work from the top down.
The use of lighter fluid, oils or any
liquid fuels is strictly forbidden
from use in a wood stove.
Fully open the combustion air into the start-up
air position and the door ajar (about one cm
open). Once the fire is established and the chim-
ney is hot (after about ten minutes) closed door
and regulate the air into operating position. We
recommend, all of the first fuel is burned with
the combustion air fully open in the operating
position. This ensures the stove and chimney
are thoroughly heated.
If the fire dies down completely or embers are
smoldering, then it will be necessary to place
2
Closed
3
some firelighters onto the grate with some kind-
ling or small pieces of wood to the fire once
again. Leave the air control fully open and allow
the fire to build before refueling with larger pie-
ces of wood. Then adjust the air control for op-
timum combustion. Do not overload the firebox
by loading above the tertiary air diffuser at the
back of the firebox and ensure that the wood is
retained by the log guard. Always ensure that
the wood is not tightly stacked so that air can
circulate freely.
Do not leave the door open:
Operation with the door open can cause excess
smoke. The appliance must not be operated
with the appliance door left open except as di-
rected in the instructions.
Do not leave the air control completely open:
Operation with the air control permanently open
can cause excess smoke. The appliance must
not be operated with air controls or dampers left
open except as directed in the instructions.
Startup/Lighting
Scan the code and select a language.

1.5 refueling

Refueling of your stove should be done while
there is still a good layer of embers. Distribu-
tethe embers with the majority of them to the
front. Place pieces of wood equivalent to about
1,2 kg on top of the embers perpendicular to the
door. Now open the combustion air completely.
If the
Be careful when emptying the
ashes out. There can be hot embers
left for a long time.
5