Heta SCAN-LINE 550 Operating And Installation Instructions
Hide thumbs
Also See for SCAN-LINE 550:
- Operating instructions manual (13 pages) ,
- Operating and installation instructions (12 pages) ,
- Operating and installation instructions (28 pages)
Related Manuals for Heta SCAN-LINE 550
Summary of Contents for Heta SCAN-LINE 550
- Page 1 550 inset stove www.heta.dk Danish DesiGn . Danish QUality . Danish ProDUCtion...
-
Page 2: Installation Instructions
The Scan-Line 550 inset stove has been approved according to the EN 13229, DIN+, and 15a B-VG. Approval means that consumers can be sure, that the stove meets a range of specifications and requirements intended to ensure that the materials used are of good quality, that the stove does not adversely affect the environment, and hat it is economical to use. - Page 3 with roof support so that the top panel of the - The house is too airtight (i.e. when there is an stove is not required to bear the entire weight of insufficient supply of fresh air). the chimney (excessive weight may damage the - Poor smoke extraction (poor draft conditions) stove).
- Page 4 assembling the convection box 3. Before the convection box is installed you 1. The flue collar is always put in the combu- have to make up your mind if the inset sto- stion chamber. The flue collar is fitted on the ve should pass on heat to some stone mass chimney pipe where the inset stove later will (thermal mass stove effect).
- Page 5 Screws for fitting the Front frame front frame Fitting the collar for external air inlet 1. Remove/hit the cut out ring at the bottom of 4. Install the stove into the convection box as the convection box. previously described and press the external air inlet collar against the bottom of the st- 2.
- Page 6 instrUCtions For Use First firing heating value in wood The stove paint is fully cured from the factory, You have to use about 2.4 kg normal wood to but a minor unpleasant odour could still arise. replace one litre of heating oil. All woods have almost the same heating value per kg, which Fuel is about 5.27 kW/hour for absolute dry wood.
- Page 7 up airflow for the stove, push the handle on the stove, as this may lead to overheating. It must start-up mechanism as far to the right-hand side only be used until the fuel is burning with a of the stove (as seen from the front) as possible. steady flame.
-
Page 8: Operational Problems
stove data table in accordance with en 13229 testing. Stove type Nominal Smoke Fuel Draught Nominal output Heat Distance to Distance to Stove Scan-Line fluegas flammable materials furnitures from stub volume tested output weight inset stove the stove temperature at the sides mbar C°... - Page 9 550 insert stove: Materials such as fermacell gypsum fibreboard, isolath 1000, mineral wool fire batts and aerated concrete can also be used around the stove. When using materials other than fermacell gypsum fibreboard, ensure these have the same in- sulation properties as 12,5 fermacell.
- Page 10 Heta representative, who in turn will • Assembly / disassembly of warranty repair contact Heta to solve the claim. To file a claim • Any secondary damages of the stove or it’s please provide date of installation, picture of the...
- Page 11 Adress Jupitervej 22, DK 7620 Lemvig EU Declaration of Conformity E-mail heta@heta.dk Website www.heta.dk DoC Scan-Line 550 insert RRF-29 08 1700-2008 Telephone +45 9663 0600 Product fiche Model identifier Scan-Line 550 Insert stove The identified product described above is in...
Need help?
Do you have a question about the SCAN-LINE 550 and is the answer not in the manual?
Questions and answers