Operating Instructions; Before Using; First Firing; Regulating The Airflow - Heta Vista Operating And Installation Instructions

1. oPeratinG instrUCtions

1.1 Before using

Before the wood stove is used make sure re-
quired installation conditions, are met.
See page 16.
1
Combustion
chamber
Stove door

1.2 first firing

The stove paint is fully cured from the factory,
but a minor unpleasant odour could still arise.
1.3 regulating the air flow
A handle below the door regulates the stoves
combustion air. Fig. 2
The combustion air is fully open, when the hand-
le is pushed to the right. Closes gradually mo-
ving the lever to the left.
2
Closed

1.4 lighting the stove

Place two pieces of wood on the bottom. Stack
kindling on top in layers with air between. Set-
ting fire starter (bag, brick, paraffin) on the top,
now you are ready to light the fuel. The flames
must work from the top down.
The use of lighter fluid, oils or any
liquid fuels is strictly forbidden
from use in a wood stove.
Baffle Plate
Air regulating
handle
Open
3
Fully open the combustion air and leave the
door ajar (about 1 cm open).
Once the fire is established and the chimney is
hot (after about 3-5 minutes) closed door and
regulate the air into operating position. We re-
commend, all of the first fuel is burned with the
combustion air fully open in the operating po-
sition. This ensures the stove and chimney are
thoroughly heated.
Startup/Lighting
Scan the code and select a language.

1.5 refueling

Refueling of your stove should be done while
there is still a good layer of embers. Distribute
the embers with the majority of them to the
front. Place pieces of wood equivalent to about
1,76 kg - Vista and 1,25 kg. - Vista S on top of
the embers.
Open the combustion air completely and pos-
sibly. the door ajar (it is not necessary to keep
the door ajar, but it can accelerate the ignition
of the wood).
The wood will then ignite within a very short time
(Typically 1 to 3 minutes). Once the fuel is Ignited.
Close the door and regulate the air back to ope-
rating air. When the fire is well established, you
can now regulate the operating air to the desired
combustion level.
4
5