Entering The Node Id - GE HygroPro User Manual

Chapter 2: Operation
2.2.5 Setting Up the Analog Output (cont.)
In the Output menu, select Trim and press enter. The following
screen appears:
When you select the Mode option at the above prompt, choose either
Test to verify the output or Normal for normal operation.

2.2.6 Entering the Node ID

The Node ID is a unique network identifier that enables the HygroPro
to be connected to a multi-drop network when used with PanaView™
interface software. To enter your Node ID, proceed as follows:
Page 28
Enter your values for the
and
Span Trim
procedures as on the previous page.
Enter your passcode to access the setup
program. Then use the arrow keys to
select the Node ID menu. Press enter.
Use the arrow keys to enter the desired
Node ID value and press enter.
Base Trim
, using the same
%
HygroPro User's Manual
,