Heat Sink - HP ENVY x360 13 Maintenance And Service Manual

Heat sink

Table 5-11 Heat sink spare part information
Description
Heat sink (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. System board (see
Remove the heat sink:
1. Remove the four Phillips M2.0×4.0 screws (1) that secure the heat sink to the system board.
2. Remove the heat sink (2).
Each time the heat sink is removed, thoroughly clean the thermal material from the processor component (1)
and the surface of the heat sink (2). Replacement thermal material is included with the heat sink and system
board spare part kits.
Bottom cover on page
Battery on page 33)
Solid-state drive on page
Fan on page 38)
System board on page
30), and then remove the following components:
35)
58)
Component replacement procedures
Spare part number
L94510-001
61